Physio Logic 016-644

Physio Logic Digital 10 Thermometer User Manual

Модель: 016-644

вступ

Thank you for choosing the Physio Logic Digital 10 Thermometer. This device is designed to provide fast, accurate, and reliable temperature readings for personal health monitoring. Please read this manual thoroughly before use to ensure proper operation and to maintain the accuracy and longevity of your thermometer.

Physio Logic Digital 10 Thermometer

Image: The Physio Logic Digital 10 Thermometer, a white, slender device with a digital display and the Physio Logic logo.

Особливості продукту

  • Provides clinically proven accuracy for temperature readings.
  • Delivers results in less than ten seconds.
  • Displays temperature in either Fahrenheit or Celsius.
  • Accurate within 0.2 degrees F / 0.1 degrees C.
  • Beeps when peak temperature has been reached.
  • Conveniently water resistant for easy cleaning and hygiene.
  • Includes auto shut-off for extended battery life.
  • Comes with a handy storage case for safe keeping.
Physio Logic Digital 10 Thermometer Packaging

Image: The retail packaging for the Physio Logic Digital 10 Thermometer, highlighting its 10-second results and water-resistant features.

Налаштування

Установка батареї

The Physio Logic Digital 10 Thermometer comes with one product-specific battery included and pre-installed. If the battery needs replacement, carefully open the battery compartment located at the end opposite the tip. Insert a new battery, ensuring correct polarity, and securely close the compartment.

Initial Power-On and Unit Selection

  1. Натисніть кнопку живлення, щоб увімкнути термометр. Пролунає короткий звуковий сигнал, і на дисплеї короткочасно відобразяться всі сегменти, а потім остання виміряна температура.
  2. To switch between Fahrenheit (°F) and Celsius (°C), ensure the thermometer is off. Press and hold the power button for approximately 3 seconds until the unit changes on the display. Release the button to set the desired unit.
  3. Термометр тепер готовий до використання.

Інструкція з експлуатації

Вимірювання температури

  1. Натисніть кнопку живлення, щоб увімкнути термометр.
  2. Place the thermometer tip according to the desired measurement method:
    • Пероральне застосування: Place the tip under the tongue, as close to the heat pocket as possible. Keep mouth closed.
    • Пахвове (під пахвами) використання: Place the tip in the armpit, ensuring good skin contact. Hold arm firmly against the body.
    • Ректальне застосування: Нанесіть водорозчинне мастило на кінчик. Обережно введіть кінчик у пряму кишку не глибше ніж на 1,25 см.
  3. Hold the thermometer in place until the peak temperature is reached, indicated by a series of beeps (approximately 10 seconds).
  4. Зчитайте температуру, що відображається на екрані.
  5. Натисніть кнопку живлення, щоб вимкнути термометр, інакше він автоматично вимкнеться приблизно через 10 хвилин бездіяльності, щоб заощадити час роботи батареї.

Технічне обслуговування

Очищення та дезінфекція

The thermometer is water resistant and can be easily cleaned. After each use, wipe the tip and shaft with a soft cloth dampened with isopropyl alcohol (70% concentration) or soap and water. Do not immerse the entire thermometer in water or any cleaning solution. Allow to air dry before storing.

Зберігання

Store the thermometer in its handy storage case when not in use. Keep it in a cool, dry place, away from direct sunlight and extreme temperatures. Ensure the thermometer is clean and dry before storing.

Physio Logic Digital 10 Thermometer in Storage Case

Image: The Physio Logic Digital 10 Thermometer resting inside its protective clear plastic storage case.

Заміна батареї

When the battery symbol appears on the display, it indicates that the battery is low and needs replacement. Refer to the 'Battery Installation' section under Setup for instructions.

Усунення несправностей

  • Ask a question about this manual

    Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.