вступ
This manual provides essential information for the proper assembly, operation, and maintenance of your Bounty Hunter VLF2.1 Metal Detector. Please read these instructions thoroughly before using the device to ensure optimal performance and longevity.
Інформація про безпеку
- Безпека батареї: Always use the correct type and size of batteries. Ensure batteries are inserted with correct polarity. Do not mix old and new batteries, or different types of batteries. Remove batteries if the device will not be used for an extended period.
- Не для дітей: This product is not suitable for children. Adult supervision is required if used by individuals under 18.
- Екологічна обізнаність: Be aware of your surroundings when operating the metal detector. Avoid areas with live electrical cables or unexploded ordnance.
- Безпека копання: Always obtain permission before searching on private property. Exercise caution when digging to avoid damaging underground utilities or historical artifacts.
Вміст упаковки
Перевірте наявність усіх предметів у вашій упаковці:
- Bounty Hunter VLF2.1 Metal Detector Unit
- Інструкція з експлуатації (цей документ)
Налаштування
1. Встановлення батареї
The VLF2.1 Metal Detector requires two 9V batteries (not included).
- Locate the battery compartment, typically on the underside or rear of the control housing.
- Відкрийте кришку батарейного відсіку.
- Insert two 9V batteries, ensuring correct polarity (+ and - terminals match the markings inside the compartment).
- Надійно закрийте кришку батарейного відсіку.
2. Збірка
Assemble the metal detector by connecting the search coil to the lower stem, then attaching the lower stem to the upper stem, and finally securing the control housing to the upper stem. Ensure all connections are tight but do not overtighten.
3. Adjusting the Detector
While the length is not adjustable, ensure the search coil is parallel to the ground when held comfortably. The armrest should support your forearm, allowing for comfortable sweeping motions.
Інструкція з експлуатації
Панель управління завершенаview

Image: The control panel of the Bounty Hunter VLF2.1 Metal Detector. It features an analog meter labeled 'METAL DETECTOR VLF' at the top, with a needle indicating signal strength from 0 to 10. A 'BATT OK' indicator is visible on the meter. Below the meter are two rotary knobs: 'Power' on the left with an 'OFF' position, and 'Eliminator' on the right with a 'BATT TEST' position. These controls are used for sensitivity adjustment, discrimination, and battery testing.
1. Увімкнення та вимкнення живлення
To power on the detector, rotate the потужність knob clockwise from the 'OFF' position. To power off, rotate it counter-clockwise to 'OFF'.
2. Тест акумулятора
To check battery status, rotate the Елімінатор knob to the 'BATT TEST' position. The needle on the analog meter should point to the 'BATT OK' section. If it does not, replace the 9V batteries.
3. Sensitivity Control (Power Knob)
The потужність knob also controls the detector's sensitivity. Turning it clockwise increases sensitivity, allowing detection of smaller or deeper objects. However, higher sensitivity can also increase false signals in mineralized ground or areas with electrical interference. Adjust for stable operation.
4. Discrimination Control (Eliminator Knob)
The Елімінатор knob allows you to filter out unwanted metals, such as iron. Turning this knob clockwise increases the level of discrimination. This means the detector will ignore certain types of metal, indicated by a lack of audio response. Experiment with this setting to find the optimal balance for your search environment.
5. Search Modes
The VLF2.1 offers 2 search modes, typically controlled by the discrimination setting:
- All-Metal Mode: With the Eliminator knob set to its lowest discrimination, the detector will respond to all types of metal. This mode offers the greatest depth detection.
- Режим дискримінації: As you increase the Eliminator setting, the detector will begin to ignore iron and other unwanted targets, allowing you to focus on more desirable metals.
6. Detecting Objects
Sweep the search coil slowly and steadily from side to side, keeping it parallel to the ground and approximately 1-2 inches above the surface. When a metal object is detected, the detector will emit an audible tone, and the needle on the analog meter will move. The volume of the tone is proportional to the signal strength, indicating the proximity and size of the object. Coin-sized objects can be detected up to 5 inches deep, with larger items detectable at greater depths.
Технічне обслуговування
- Прибирання: Протріть детектор рекламоюamp cloth after each use. Avoid using abrasive cleaners or solvents. The search coil is weather-resistant but the control housing is not fully waterproof; avoid submerging it.
- Зберігання: Store the detector in a dry, cool place. Remove batteries if storing for extended periods to prevent leakage.
- Захист котушки: Consider using a coil cover (if available) to protect the search coil from scratches and abrasion.
Усунення несправностей
Немає живлення
- Перевірте встановлення батареї та її полярність.
- Переконайтеся, що акумулятори свіжі та повністю заряджені.
- Perform a battery test using the Eliminator knob.
Erratic Signals / False Signals
- Зменшити потужність (sensitivity) setting.
- Збільшити Елімінатор (discrimination) setting to filter out unwanted metals or ground mineralization.
- Ensure no other electronic devices are operating nearby.
- Check that the search coil cable is securely connected and not damaged.
Weak or No Detection
- Збільшити потужність (sensitivity) setting.
- Ensure the search coil is being swept correctly and close to the ground.
- Verify batteries are fresh.
Технічні характеристики
| Бренд | Мисливець за головами |
| Номер моделі | BOU-VLF2.1 |
| Джерело живлення | Battery Powered (2 x 9V batteries, not included) |
| Вага товару | 2.9 фунта |
| Тип дисплея | LED (Analog Meter) |
| Розміри предмета (Д x Ш x В) | 24.9 см x 7.3 см x 5.6 см |
| Міжнародний захист рейтингу | IP66 |
| Рекомендоване використання | Детектор металу |
Гарантія та підтримка
The Bounty Hunter VLF2.1 Metal Detector comes with a 1-річна гарантія виробника. For warranty claims or technical support, please refer to the contact information provided with your purchase documentation or visit the official Bounty Hunter webсайт. Зберігайте підтвердження покупки для підтвердження гарантії.